The EV-TEST100 in combination with appropriate HT multi-function instrument simulates an electric vehicle connected to the charging station, allowing you to verify the EVSE full functionality and electrical safety. EV-TEST100 is able to test charging stations with charging modes 2 and 3 and Type 2 connector (European standard).
Thanks to the simulation of the vehicle’s status it is possible to verify that, starting from status B, the recharging column blocks the cable’s release.*
* Only for charging stations equipped with an interlock system
Simulation of Fault PE and CP
Through the knob it is possible to carry out in a sequence the simulation of the interruption of the protective conductor (Fault PE) and the simulation of an error on the CP signal (Fault E).
Monitoring of PWM Output
Through the dedicated output and the provided C100EV cable it is possible to verify the recharging mode and the encoding of the recharging current through the acquisition of the PWM signal (pulse width modulation).
Verification of Control Pilot
Through PP knob, rated currents of charging cables can be simulated, up to 63A.
Verification of Proximity Pilot
Possibility of simulating the various current capacitances of the recharging cable, up to 63A, when EV-TEST 100 is connected to the recharging station.*
* Only for charging stations supporting this function